HOW TO USE FIBER CLIPS

　　Fiber Clamp is one of our products. Let me introduce you how to use it.

　　This instrument is generally used in conjunction with other instruments (light source, optical telephone, etc.). The specific usage method is as follows.

　　①Injecting matching liquid: In order to make the optical fiber and the holder better contact and reduce the reflection, generally, a little optical fiber matching liquid should be added to the holding groove of the holder before use. Hold the gripper handle, open the fiber clamp, and add an appropriate amount of fiber matching solution (just enough to coat) in the clamp base plate. Too much injection will reduce the binding efficiency.

　　②Place the optical fiber: Confirm the coming and going direction of the optical fiber, when it is consistent with the direction of OPT IN/0uT marked on the instrument, put the optical fiber into the V-shaped groove of the clamper.

　　③Check the position of the fiber: confirm whether the fiber is placed in the V-shaped groove, and then pull the fiber to the right for about 10mm.

　　④Clamp the optical fiber: loosen the gripper handle, and completely clamp the optical fiber until it is ready for use.

　　⑤ Take out the optical fiber: When the use is over, hold the handle of the holder, open the optical fiber clamp, take out the optical fiber, and then use a cotton swab to clean the matching liquid on the holder substrate and the optical fiber clamp (it is forbidden to use water ethanol or acetone), and finally release the gripper handle.

　　Drop Wire Clamp is also one of our products, welcome to visit our website!